Back to Blog
Type: arp -a (look for the MAC address of your access point, and note its IP address) Note: If a secondary AP is not in the ARP list of interfaces, you can also find its assigned IP by logging in to the main NAT router, and looking for it at the LAN wired clients list. ![]() Ping your network address (substitute your client IP's last number with. Find the MAC address of your access point (it is usually printed on its label). If the above does not work, or you have multiple access points and you are not connected to the main router, you can try the following solution: 1. In the list, find the line that is your "Default Gateway", this is your primary router/access point. Start > Run > type: cmd (to enter command prompt) 2. If the access point is the main " gateway" NAT router on your network: 1. ![]() A bit inconvinient in version 6.xx as you cantt copy the results. In the the dashboard under Access Points you can customize columns to show the MAC address as well. You can always try doing a factory reset of the ap, and connect to its default IP address (with its factory username/password), but then you have to reconfigure it to work with your network. Basically you dont need a special tool but just use the controller. The IP address may, or may not show in the DHCP client list on your main router/gateway. Press Cancel to return to the Network menu. Choose the Hardware tab under which you will see the MAC address of your wireless card. Choose Wi-Fi from the list of interfaces on the left and click the Advanced button. You need the AP IP to be able to connect and reconfigure it. Click Network from the System Preferences menu. Sometimes you can have a wireless access point on your network that you do not know the IP address of.
0 Comments
Read More
Leave a Reply. |